> Click here to return to the Construction Equipment Guide homepage.    This site can also be read in  
|
|
|
|
|
|
|
 
Touch for Navigation


Maddock Adds to Backhoe Mill Line

The EM48 is powered by the excavator hydraulic system and gives the operator clear view of the work area. It uses standard ¾ in. (1.9 cm) shank tungsten-carbide cutter bits and can cut asphalt, concrete and rock, such as limestone. Its ability to cut above and below grade allows the EM48 to cut walls and in trenches.

The EM48 is powered by the excavator hydraulic system and gives the operator clear view of the work area. It uses standard ¾ in. (1.9 cm) shank tungsten-carbide cutter bits and can cut asphalt, concrete and rock, such as limestone. Its ability to cut above and below grade allows the EM48 to cut walls and in trenches.

Maddock Construction Equipment LLC has a new addition to the Backhoe Mill line of milling attachments. The EM48 attachment has a 48 in. (122 cm) cutting width, 11 in. (28 cm) cutting depth and can be pre-set to cutting depths from flush to full depth in ½ in. (1.3 cm) increments.

The EM48 is powered by the excavator hydraulic system and gives the operator clear view of the work area. It uses standard ¾ in. (1.9 cm) shank tungsten-carbide cutter bits and can cut asphalt, concrete and rock, such as limestone. Its ability to cut above and below grade allows the EM48 to cut walls and in trenches. An optional water spray system directs small water streams into the drum housing to help control dust.