Bomag BM1200/35 Cold Mill Features Rear Cutter System

The Bomag cutter design incorporates a single bolt for holder retention and requires a low tightening torque of 75 ft./lb.

📅   Wed May 06, 2015 - National Edition
CEG


The Bomag BM1200/35 offers three milling drum speeds — 85, 95 and 107 rpm — to match cutting speed to jobsite conditions.
The Bomag BM1200/35 offers three milling drum speeds — 85, 95 and 107 rpm — to match cutting speed to jobsite conditions.

Offering a 47.2-in. (120 cm) cutting width and 13-in. (33 cm) maximum cutting depth, the Bomag BM1200/35 cold milling machine features a rear rotor design with a cutter system that optimizes milling performance. Constructed with the BMS 15 interchangeable holder system, the Bomag cutter design incorporates a single bolt for holder retention and requires a low tightening torque of 75 ft./lb. Low front face position increases milling efficiency and overall milling power. Specially tempered steel material offers significantly longer service life compared to conventional cutting systems to maximize BM1200/35 uptime, according to the manufacturer.

Drawing from operator feedback, this cold milling machine’s design includes logical operating layout, intuitive controls and low noise levels. Its vibration isolated operator’s platform features a comfortable swivel seat design, allowing all work to be completed while seated. The ergonomically designed dashboard includes intuitive switches, levers and clear readout displays.

The Bomag BM1200/35 offers three milling drum speeds — 85, 95 and 107 rpm — to match cutting speed to jobsite conditions. Material is efficiently channeled from the cutter housing and into haul trucks via 25.6 in. (65 cm) wide inside and 23.6 in. (60 cm) wide outside conveyors at capacities reaching 6,357 cu. ft./hr. (180 cu m/hr). The outside conveyor swivels 45 degrees to the left and right to efficiently load trucks directly in front or from either side of the mill. Maximum discharge height for the BM1200/35’s conveyor is 224.4 in. (570 cm).

Powered by a Tier IV Final 349 hp (260 kW) MTU diesel engine, the BM1200/35 offers ample power to efficiently mill asphalt at speeds reaching 105 fpm (32 m). An efficient pressurize water injection system offers a variable flow rate of 0 to 1.6 gpm (0 to 6 Lpm) to the cutter housing to cool cutting teeth and increase service life.

For more information, call 803/337-0700 or visit www.bomag.com/us.