List Your Equipment  /  Dealer Login

Roadtec CIR Additive System Ideal for Materials Blending in Pavement Rehab

Mon July 10, 2017 - National Edition
Construction Equipment Guide


The Roadtec CIR additive system is used in the cold-in-place recycling of asphalt pavement in the repair and rehabilitation of asphalt-paved roads. Mounted to the rear of the milling machine, the CIR additive system is the same width as the mainframe of the milling machine.
The Roadtec CIR additive system is used in the cold-in-place recycling of asphalt pavement in the repair and rehabilitation of asphalt-paved roads. Mounted to the rear of the milling machine, the CIR additive system is the same width as the mainframe of the milling machine.

The Roadtec CIR additive system is used in the cold-in-place recycling of asphalt pavement in the repair and rehabilitation of asphalt-paved roads. The system is used to transfer, measure and inject either emulsion or foamed asphalt to the cutter housing of the milling machine. The additive is then thoroughly blended with the milled material and transferred for paving.

Roadtec cold-in-place recycling (CIR) equipment makes it possible to repair damage to a roadway in one single pass, while reusing up to 100 percent of the existing material. Savings potentials are expected to be significant, not only through re-use of material, but also by reducing equipment requirements, and through time savings, according to the manufacturer.

The CIR process removes a portion of an existing asphalt pavement by milling to a depth of 2 to 4 in. (5 to 10 cm), and then repaving it with reworked asphalt-mix with additives. As the name implies, CIR is accomplished without heating the asphalt mixture, before or after placement. Depending on the structural requirements of the overall pavement and its intended use, the CIR typically receives a wear course such as a chip seal or HMA overlay to complete the road before returning it to traffic. Single unit systems do not include a method of screening and crushing.

Mounted to the rear of the milling machine, the CIR additive system is the same width as the mainframe of the milling machine.

For more information, visit www.roadtec.com.




Today's top stories

Eagle Bridge Co. Works On Final Leg of U.S. 35 Upgrade

Fay Preps Way for Pittsburgh International Airport Modernization Project

Volvo CE Continues to Perform, Transform During Slower Q1 2024

American Bridge Co. Leads Conn.'s East Haddam Swing Bridge Project

Pettibone Celebrates 75th Anniversary of Cary-Lift

Common Ground Alliance Hosts Conference & Expo in Colorado On Preventing Utility Damages

Going Beyond Diversity: Star Equipment's Rental Advantage

Volvo CE Launches Updated L30, L35 Compact Wheel Loaders


 






aggregateequipmentguide-logo agriculturalequipmentguide-logo craneequipmentguide-logo forestryequipmentguide-logo truckandtrailerguide-logo
39.96250 \\ -83.00610 \\ Columbus \\ PA