Construction Equipment Guide
470 Maryland Drive
Fort Washington, PA 19034
800-523-2200
| Articulated/Rigid | Rigid - Starting 2019 |
|---|---|
| Drive Configuration | RWD - Starting 2019 |
| Drive System Mech/Electr. | AC Elec - Starting 2019 |
| Engine Type | Komatsu SDA16V160 - Starting 2019 |
| Mfg. Model | 830E-1AC - Starting 2019 |
| Operating Weight | 850,650.00 lbs (385,848.83 kg) - Starting 2019 |
| Rated Payload | 244.00 t (244,000.00 kg) - Starting 2019 |
| Canopy Sheet | 5 mm 0.19\'\' 690 mPa 100,000 psi |
|---|---|
| Capacity Struck | 153.1 cu yd |
| Floor Sheet | 19 mm 0.75\'\' 1379 mPa 200,000 psi tensile strength steel (two-piece) |
| Front Sheet | 12 mm 0.47\'\' 1379 mPa 200,000 psi tensile strength steel |
| Heaped (2:1, Sae) | 192.3 cu yd |
| Payload | 488,650.20 lbs (221,648.28 kg) |
| Side Sheet | 8 mm 0.31\'\' 1379 mPa 200,000 psi tensile strength steel |
| Structure | Flat floor configuration |
| Weight | 60,999.70 lbs (27,669.03 kg) |
| Cooling System | 116.50 gal (440.95 l) |
|---|---|
| Crankcase | 59.00 gal (223.32 l) |
| Fuel Tank | 831.10 gal (3,145.71 l) |
| Hydraulic System | 210.10 gal (795.23 l) |
| Motor Gear Box | 10.10 gal (38.23 l) |
| Overall Height | 22.58 ft (6.88 m) |
|---|---|
| Overall Length | 47.25 ft (14.40 m) |
| Turning Radius | 46.59 ft (14.20 m) |
| Wheelbase | 20.84 ft (6.35 m) |
| Width Over Tires-Front | 22.51 ft (6.86 m) |
| Width Over Tires-Rear | 23.92 ft (7.29 m) |
| Electric Dynamic Retarder (Max.) | 2983kW Continuously rated high-density blown grids w/retard at engine idle and reverse propulsion.? |
|---|---|
| Emergency Brakes | Automatically applied prior to hydraulic system pressure dropping below level required to meet secondary stopping requirements. |
| Front | Wheel speed disc. Three calipers on a 1213 mm / 47.75\" O.D. disc |
| Parking Brake Type | Spring-applied, hydraulically released, with speed application protection.? |
| Rear | Dual disc armature speed. Two 635 mm / 25\" O.D. discs per side. One caliper per disc. |
| Service Brake Type | all-hydraulic actuated |
| Wheel Brake Locks | Switch-activated? |
| Alternator | G.E.GTA - 49 |
|---|---|
| Control | AC Torque Control System |
| Maximum Speed (Km/H) | ?64 |
| Motorised Wheels | GEB25 |
| Ratio | 31.875:1 |
| Alternator | 24 volt, 140 amp |
|---|---|
| Cranking Motors | Two/24 volt |
| Lighting | 24 volt |
| Displacement | 3,661.50 cu in (60,001.37 cu cm) |
|---|---|
| Engine Make | 2238 |
| Engine Model | SDA16V160 |
| Fuel Type | Diesel |
| Horse Power: Iso 9249 / Sae J1349 | 2,361.60 hp (1,761.07 kw) |
| Horse Power: Sae J1995 | 2,501.10 hp (1,865.10 kw) |
| Number Of Cylinders | 16 |
| Operating Cycle | 4-cycle |
| Power Measured @ | 1900 rpm |
| Weight | 21,182.10 lbs (9,608.05 kg) |
| Filtration | In-line replaceable elements |
|---|---|
| Hoist And Steering | Dual, in-line, high pressure |
| Hoist Cylinder | Two 3-stage dual-acting outbound cylinders and internal cushion valve, over-centre damping |
| Hoist Time | Power-up loaded: 21 sec; Power-down: 16 sec; Float-down empty: 17 sec |
| Pumps | Tandem gear-type pump |
| Relief Pressure | Hoist-17240 kPa 2,500 psi, Steering and brake-27580 kPa 4,000 psi |
| Reservoir | 238.00 gal (900.83 l) |
| Suction | Single, full flow, 100 mesh |
| Turning Circle Diameter (Sae) | 93.00 ft (28.35 m) |
| Front | 335 |
|---|---|
| Rear | 279 |
| Standard Tire | 40.00R57 |
|---|
| Empty Weight | 361,999.10 lbs (164,200.23 kg) |
|---|---|
| Gross Weight | 850,649.20 lbs (385,848.47 kg) |
| Weight Distribution Front - Empty | 50 % |
| Weight Distribution Front - Loaded | 33 % |
| Weight Distribution Rear - Empty | 50 % |
| Weight Distribution Rear - Loaded | 67 % |