Construction Equipment Guide
470 Maryland Drive
Fort Washington, PA 19034
800-523-2200
| Articulated/Rigid | Rigid - Starting 2019 |
|---|---|
| Drive Configuration | RWD - Starting 2019 |
| Drive System Mech/Electr. | AC Elec - Starting 2019 |
| Engine Type | Komatsu SSDA18V170 - Starting 2019 |
| Mfg. Model | 930E-4SE - Starting 2019 |
| Operating Weight | 1,115,000.00 lbs (505,756.12 kg) - Starting 2019 |
| Rated Payload | 320.00 t (320,000.00 kg) - Starting 2019 |
| Canopy Sheet | 5 mm 0.19\\\'\\\' 690 mPa 100,000 psi tensile strength steel |
|---|---|
| Capacity Struck | 223.7 cu yd |
| Floor Sheet | 16 mm 0.63\'\' 1379 mPa 200,000 psi tensile strength steel (two-piece) |
| Front Sheet | 9 mm 0.35\'\' 1379 mPa 200,000 psi tensile strength steel |
| Heaped (2:1, Sae) | 276 cu yd |
| Loading Height | 23.20 ft (7.07 m) |
| Payload | 640,328.20 lbs (290,448.35 kg) |
| Side Sheet | 8 mm 0.31\'\' 1379 mPa 200,000 psi tensile strength stee |
| Structure | Flat floor configuration |
| Weight | 66,936.80 lbs (30,362.06 kg) |
| Cooling System | 190.00 gal (719.15 l) |
|---|---|
| Crankcase | 90.10 gal (341.03 l) |
| Fuel Tank | 1,400.20 gal (5,299.76 l) |
| Hydraulic System | 350.10 gal (1,325.13 l) |
| Motor Gear Box | 25.10 gal (95.00 l) |
| Overall Height | 24.18 ft (7.37 m) |
|---|---|
| Overall Length | 51.19 ft (15.60 m) |
| Turning Radius | 49.87 ft (15.20 m) |
| Wheelbase | 20.84 ft (6.35 m) |
| Width Over Tires-Front | 24.68 ft (7.52 m) |
| Width Over Tires-Rear | 27.33 ft (8.33 m) |
| Electric Dynamic Retarder (Max.) | 4026 |
|---|---|
| Emergency Brakes | Automatically applied prior to hydraulic system pressure dropping below level required to meet secondary stopping requirements. |
| Max. Service Apply Pressure (Kpa) | 2500.1 psi |
| Parking Brake Type | ?Multiple disc, spring-applied, hydraulically-released, dry brakes on inboard end of each wheel motor rotor shaft. Rated to hold on ±15% grade at maximum gross vehicle weight. |
| Service Brake Type | Oil-cooled, hydraulic-actuated, multiple disc brakes at each wheel. |
| Total Friction Area Per Brake (Cm2) | 97025 cm2 , 15038 in2 |
| Wheel Brake Locks | Switch-activated? |
| Alternator | GTA -39 |
|---|---|
| Control | AC Torque Control System |
| Maximum Speed (Km/H) | ?64.5 |
| Motorised Wheels | GDY106 Induction Traction Motors |
| Ratio | 32.62:1 |
| Alternator | 24 volt, 140 amp |
|---|---|
| Cranking Motors | Two/24 volt |
| Lighting | 24 volt |
| Displacement | 4,759.90 cu in (78,000.96 cu cm) |
|---|---|
| Engine Make | 2238 |
| Engine Model | SSDA18V170 |
| Fuel Type | Diesel |
| Horse Power: Iso 9249 / Sae J1349 | 3,345.90 hp (2,495.08 kw) |
| Horse Power: Sae J1995 | 3,501.50 hp (2,611.11 kw) |
| Number Of Cylinders | 18 |
| Operating Cycle | 4-cycle |
| Power Measured @ | 1900 rpm |
| Weight | 22,266.70 lbs (10,100.02 kg) |
| Filtration | In-line replaceable elements |
|---|---|
| Hoist And Steering | Dual, in-line, high pressure |
| Hoist Cylinder | Two 3-stage dual-acting outbound cylinders and internal cushion valve, over-centre damping. |
| Hoist Time | Power-up loaded: 21 sec; Power-down: 23 sec; Float-down empty:24 sec |
| Pumps | Two pumps, single package, end of alternator |
| Relief Pressure | Hoist and brake cooling- 17237 kPa 2,500 psi Steering and brake-25759 kPa 4,000 psi |
| Reservoir | 250.00 gal (946.25 l) |
| Suction | Single, full flow, 100 mesh |
| Turning Circle Diameter (Sae) | 97.70 ft (29.78 m) |
| Standard Tire | 53/80 R63 |
|---|
| Empty Weight | 474,670.70 lbs (215,307.28 kg) |
|---|---|
| Gross Weight | 1,114,998.90 lbs (505,755.62 kg) |
| Weight Distribution Front - Empty | 48.5 % |
| Weight Distribution Front - Loaded | 32.8 % |
| Weight Distribution Rear - Empty | 51.5 % |
| Weight Distribution Rear - Loaded | 67.2 % |