Construction Equipment Guide
470 Maryland Drive
Fort Washington, PA 19034
800-523-2200
| Articulated/Rigid | Rigid - Starting 2019 |
|---|---|
| Drive Configuration | RWD - Starting 2019 |
| Drive System Mech/Electr. | AC Elec - Starting 2019 |
| Engine Type | Komatsu SSDA18V170 - Starting 2019 |
| Mfg. Model | 960E-2K - Starting 2019 |
| Operating Weight | 1,270,000.00 lbs (576,063.03 kg) - Starting 2019 |
| Rated Payload | 360.00 t (360,000.00 kg) - Starting 2019 |
| Canopy Sheet | 06mm 0.24\" 690 Mpa 1,00,000 psi tensile strength steel |
|---|---|
| Capacity Struck | 194.9 cu yd |
| Floor Sheet | 16 mm 0.63\" Outer, 19mm 0.75\" Center, 1379 mPa 200,000 psi tensile strength steel |
| Front Sheet | 10 mm 0.39\" Outer, 12mm 0.47\" Center, 1379 mPa 200,000 psi tensile strength steel |
| Heaped (2:1, Sae) | 280 cu yd |
| Loading Height | 23.50 ft (7.16 m) |
| Payload | 719,996.70 lbs (326,585.42 kg) |
| Side Sheet | 10 mm 0.39\" 1379 Mpa 2,00,000 psi tensile strength steel |
| Structure | Flat floor configuration |
| Weight | 89,999.40 lbs (40,823.09 kg) |
| Cooling System | 190.00 gal (719.15 l) |
|---|---|
| Crankcase | 90.10 gal (341.03 l) |
| Fuel Tank | 1,400.20 gal (5,299.76 l) |
| Hydraulic System | 350.10 gal (1,325.13 l) |
| Motor Gear Box | 37.00 gal (140.05 l) |
| Overall Height | 25.17 ft (7.67 m) |
|---|---|
| Overall Length | 503.29 ft (153.40 m) |
| Turning Radius | 52.50 ft (16.00 m) |
| Wheelbase | 21.76 ft (6.63 m) |
| Width Over Tires-Rear | 28.68 ft (8.74 m) |
| Electric Dynamic Retarder (Max.) | 4620 |
|---|---|
| Emergency Brakes | Automatically applied prior to hydraulic system pressure dropping below level required to meet secondary stopping requirements.? |
| Max. Service Apply Pressure (Kpa) | 2750 psi |
| Parking Brake Type | ?Multiple disc, spring-applied, hydraulically-released, dry brakes on inboard end of each wheel motor rotor shaft. Rated to hold on ±15% grade at maximum gross vehicle weight. |
| Service Brake Type | Oil-cooled, hydraulic-actuated, multiple disc brakes at each wheel. |
| Total Friction Area Per Brake (Cm2) | 103729 |
| Wheel Brake Locks | Switch-activated? |
| Alternator | Siemens |
|---|---|
| Control | AC Torque Control System |
| Drive System | Komatsu AC Drive |
| Dual Fan Main Blower | Alternator Flow- 266 m3/min 9,380 cfm Wheel Motor Flow- 419 m3/min 14,800 cfm |
| Maximum Speed (Km/H) | ?64.5 |
| Ratio | 38:12 :1 |
| Alternator | 24 volt, 250 amp |
|---|---|
| Cranking Motors | Two/24 volt |
| Lighting | 24 volt |
| Displacement | 4,759.90 cu in (78,000.96 cu cm) |
|---|---|
| Engine Make | 2238 |
| Engine Model | SSDA18V170 |
| Fuel Type | Diesel |
| Horse Power: Iso 9249 / Sae J1349 | 3,345.90 hp (2,495.08 kw) |
| Horse Power: Sae J1995 | 3,500.10 hp (2,610.07 kw) |
| Number Of Cylinders | 18 |
| Operating Cycle | 4-cycle |
| Power Measured @ | 1900 rpm |
| Weight (Dry) | 24,802.10 lbs (11,250.06 kg) |
| Weight (Wet) | 25,904.40 lbs (11,750.05 kg) |
| Filtration | In-line replaceable elements |
|---|---|
| Hoist And Steering | Dual, in-line, high pressure |
| Hoist Cylinder | Two 3-stage dual-acting outbound cylinders and internal cushion valve, over-centre damping. |
| Hoist Time | Power-up loaded: 24 sec; Power-down: 14 sec; Float-down empty:24 sec |
| Pumps | Two pumps, single package, end of alternator |
| Relief Pressure | Hoist and brake cooling- 17237 kPa 2,500 psi Steering and brake-20685 kPa 3,000 psi |
| Reservoir | 250.00 gal (946.25 l) |
| Suction | Single, full flow, 100 mesh |
| Turning Circle Diameter (Sae) | 105.00 ft (32.00 m) |
| Front | 328 |
|---|---|
| Rear | 239 |
| Standard Tire | 53/80 R63 |
|---|
| Empty Weight | 549,998.20 lbs (249,475.30 kg) |
|---|---|
| Gross Weight | 1,270,021.30 lbs (576,072.69 kg) |
| Weight Distribution Front - Empty | 49.5 % |
| Weight Distribution Front - Loaded | 33 % |
| Weight Distribution Rear - Empty | 50.5 % |
| Weight Distribution Rear - Loaded | 67 % |