Construction Equipment Guide
470 Maryland Drive
Fort Washington, PA 19034
800-523-2200
| Differential Gear | Conventional type |
|---|---|
| Drive System | Four-wheel drive |
| Final Reduction Gear | Planetary gear, sinlge reduction |
| Front | Fixed, full-floating |
| Rear | Center-pin-support, full-floating, 26 degree total Oscillation |
| Reduction Gear | Spiral bevel gear |
| Emergency Brake | Uses Parking brake |
|---|---|
| Parking Brake | Wet disc brake |
| Service Brake | Hydraulically actuated, wet disc brakes actuate on four wheels |
| Axle Each (Front & Rear) | 41.00 gal (155.19 l) |
|---|---|
| Cooling System | 38.80 gal (146.86 l) |
| Engine Oil | 22.70 gal (85.92 l) |
| Fuel Tank - Diesel | 189.70 gal (718.01 l) |
| Hydraulic Tank | 117.00 gal (442.85 l) |
| Torque Converter, Transmission And Retarder Cooling | 21.90 gal (82.89 l) |
| Blade Capacity (Sae Rated) | Straight blade-8.0 m3 (10.5 yd3); U blade-10.6 m3 (13.8 yd3) |
|---|---|
| Blade Width | Straight blade-5100 mm (16\'9\"; U blade-4870 mm (16\'0\") |
| Ground Clearance | 1.63 ft (0.50 m) |
| Height To Top Of Cab | 13.95 ft (4.25 m) |
| Max. Tilt Adjustment | Straight blade-1430 mm (4\\\'8\\\"); U blade 1340 mm (4\\\'5\\\") |
| Max.Drop Below Ground | Straight blade-450 mm (1\\\'6\\\"); U blade 490 mm (1\\7\\\") |
| Max.Lift Above Ground | Straight blade-1500 mm(4\\\"11\\\"); U blade 1485 mm (4\'10\") |
| Operating Weight | Straight blade-48100 kg 106,040 lb, U blade 49115 kg 108,280 lb |
| Overall Length | 32.24 ft (9.83 m) |
| Turning Circle | 45.81 ft (13.96 m) |
| Wheelbase | 161.42 in (410.01 cm) |
| Width Over Tires | 11.72 ft (3.57 m) |
| Alternator | 75 Ampere |
|---|---|
| Batteries | 2 x 12-Volt, 200Ah. |
| Starter Motor | 24-Volt, 7.5kW. |
| Air Cleaner | Dry type with double elements and dust evacuator , plus dust indicator |
|---|---|
| Aspiration | Turbo-charged, After cooled, , cooled EGR |
| Bore And Stroke | 170mm*170mm 6.69\"*6.69\" |
| Displacement | 1,861.30 cu in (30,501.31 cu cm) |
| Engine Make | 2238 |
| Engine Model | SAA6D170E-5 |
| Engine Type | Water-cooled, 4-cycle |
| Fan Drive Type | Hydraulic |
| Fuel System | Direct injection |
| Governor | All speed, electronic |
| Gross Power | 530.00 hp (395.23 kw) |
| Lubrication System | Method- Gear pump, force-lubrication Filter-Full-flow type |
| Net Power | 527.00 hp (392.99 kw) |
| Number Of Cylinders | 6 |
| Piston Displacement | 1,413.00 cu in (23,154.97 cu cm) |
| Power Measured @ | 1800 rpm |
| Blade Lift Control | Raise, hold lower and float |
|---|---|
| Blade Tilt And Pitch Contol | Tilt-left, hold and Tilt-right, pitch for forward and back |
| Bore And Stroke | 130mm*510mm 5.1\"*20\" |
| Control Valve | 3 spool type |
| Hydraulic System Type | Double-acting Piston type |
| No.Of Cylinders | 2 |
| Pump Flow Capacity | 43.10 gpm (163.13 lpm) |
| Pump Type | Piston-pump |
| Relief Valve Setting | 34.3 MPa 350kgf/cm2, 4980 psi |
| Articulation Angle | 43 degrees each direction |
|---|---|
| Minimum Turning Radius At The Centre Of Outside Tire | 23.30 ft (7.10 m) |
| Steering System Type | Articulated type, full-hydraulic power steering |
| Front & Rear | 45/65 R45 XLDD(L4) |
|---|---|
| Rims | 36.00-45 |
| Torque Converter | 3-elements, 1-Stage, 2-phase |
|---|---|
| Transmission | Full power-shift, planetary type |