Description:
EQUIPMENT ON LEASE, Equipment As Follows:, • Metso/Nordberg HP300 Cone Crusher, o Equipped with manganese steel crushing members – (As is - used liners), hydraulic bowl clamping and adjustment, hydraulic clearing of crusher chamber, automatic tramp iron release, bronze bearings, package lubrication system (consisting of independent pump, oil pressure switch, oil temperature switch, oil tank with strainer, oil level gauge and two thermometers, oil heater and oil filter), oil cooler (air-radiator type), tools, and 300 HP, 1.15 service factor, 1800 RPM, 460 volt, 3-phase, 60 cycle, TEFC crusher drive motor., • 2004 Deister TFM3P-3620, Triple Deck, 6’x20’ Triple Shaft, Horizontal Vibrating Screen, o Adjustable trunnion type spring support mounts on each corner, with baked epoxy coated support springs,, o Snubbers (friction checks) - spring loaded,, o 3/8" thick sideplates with 5/8" x 3-1/2" vertical braces, with 3/4" thick steel reinforcing plates bolted to sideplates between bearing housing and sideplates,, o 5/8" thick steel-flanged access ports,, o Removable back plates, rubber flap and steel combination,, o Screen cloth support panels constructed of 3" x 6" rectangular steel tube transverse members welded to formed angles bolted to the sideplates for easy replacement,, o Discharge lip protected by 3/8" thick AR steel replaceable wear plates,, o Tension plates (skirtboards),, o Either interchangeable Deister "automatic" spring tension or heavy duty tension or Deister tension wedge and "rubber spring" screen cloth tensioning devices included in the price (customer to specify type preferred, otherwise to be determined by DMCo.),, o The triple-shafted "gear-type" vibrating mechanism is located between the middle and bottom decks and equipped with 150 mm. spherical roller vibrating screen bearings,, o Steel-flanged vibrating mechanism tubes welded to the sideplates,, o Oil fill and drain plugs and the oil level gauges located on the outside surface of the vibrating mechanism end covers,, o Deister "slingermist" oil bath lubrication system, with labyrinth type dust and oil seals requiring approximately 4 gallons of oil in the vibrating mechanism end covers acting as the oil reservoir and requiring only oil changes every 500 hours,, o Each vibrating mechanism tube is protected by a 3/8" thick steel-backed rubber shield tack welded to the tube,, o 8-1/2" dia. eccentric shafts with adjustable weights for stroke adjustment,, o Bronze sleeve between bearing and shaft,, o 15" feed box with 3/8" AR steel replaceable wear plate in the bottom,, o Deister heavy duty pivoted motor base, "C" section wideband V-belts, 6 groove "C" section motor sheave and belt guard less mounting brackets,, o As per DMCo. Bulletin 333 inclined at 0-6 degrees, operating at approximately 790 RPM and with approximately 11/16" stroke and weighing approximately 26500 lbs.,, o Includes a 75 H.P., 1800 RPM, 3/60/220/440, TEFC, high starting torque, frame 365-T Toshiba motor., • 48” Under Screen Conveyor, • 42” Screen Feed Conveyor, • 42” Under Crusher Belt, • 13” Side Discharger Conveyor, • 30” Recirculating Conveyor, • Heavy Duty Chassis with Quad Axle, • Adjustable King Pin Support, • Hyd Raise and Lower, • Electric Starters, Wiring And Controls Electrical Control Panel With Structural Support To Set On Grade During Plant Operation
